Features:

• Sixteen channel / three way split per channel
• Passive unit - no power required
• Ultra low noise design
• D sub connectors on rear panel for Monitor and Auxiliary Splits (Tascam wiring)
• Transformer Balanced Inputs and Outputs
• Inputs and Main Outputs hard wired to pass Phantom Power
• Intuitive, 'user friendly' layout
• Flawless audio performance

More ARX Signal Processing:

EQ260
EQ130
EQ215

Audibox

Balance 8
DeBalance 8

MSX 48
MSX 32
MSX 8

Afterburner
Compo
Quadcomp®II
Sixgate™

e-pre
8-pre

iSwitch

BarMIX
AV stream
MIXX
MIXXMaster
MaxiMIX
MaxiSPLIT

DI6 SM
DI-Plus RC
DI-Plus 2 RC

About the MSX 48
The ARX MSX 48 Transformer isolated Microphone/Line Splitter has been developed to deliver the performance required by the increasing complexity of today’s standards of audio production.

The MSX 48 is a totally passive device requiring no power, and consists of Sixteen channels of transformer isolated ultra low noise Microphone/Line Splitter. Each of these channels has a direct looped Main/FOH feed, and a transformer isolated Monitor split on the front panel.

On the rear panel is an Auxiliary transformer isolated split ideal for use with a remote recording truck or TV feed. Duplicates of the Monitor and Aux splits are also provided on two sets of dual 25 pin D connectors on the rear panel, wired to Tascam wiring protocol.

Numbered marker panels on the front and rear provide a space where individual channel connections can be noted.

The all-steel chassis of the MSX 48 provides strong interference resistant shielding. Internally, state-of-the-art transformers deliver superb audio quality and total galvanic isolation.

The MXS 48 is the easy answer to multi channel signal splitting requirements.

Front Panel detail

Input Impedance 300 Ohms

Output Impedance 2 secondaries @ 600 Ohms each

Frequency Response 30Hz - 20 KHz ± 1dB

Maximum Output Level + 20dBm

THD at Max Output 0.2% 30 Hz - 20KHz @ 20dBm

Insertion Loss 0.5dB @ 1 KHz (600 Ohm source & load)

Input Connectors 3 pin female XLR wired Pin 2 + Hot, Pin 3 – Cold

Main Output 3 Pin male XLR wired Pin 2 + Hot, Pin 3 – Cold

Monitor & Aux Output 3 pin male XLR wired Pin 2 + Hot, Pin 3 – Cold. Audio grounds not connected; Pin 1 is floating.

Weight 13.5 lbs (6 Kg)

Front Panel

• 16 x Hardwired balanced XLR Input and Main Outputs. Pin 3–-, Pin 2 +, Pin 1 Ground
• 16 x Hardwired transformer isolated balanced XLR Monitor Splits. Pin 3–-, Pin 2 +, Pin 1 floating (not connected)
• Numbered marker panel for labelling individual channel assigns

Rear Panel

• 16 x Hardwired transformer isolated balanced XLR Auxiliary Splits. Pin 3–-, Pin 2 +, Pin 1 floating (not connected)
• 2 x D Sub connectors for Monitor Splits
• 2 x D Sub connectors for Auxiliary Splits
• Screw Terminal Chassis Ground point

Note: No connections to Audio ground