ARX UniFace Architectural Specifications



The unit shall be mounted into a standard 1 RU steel chassis with extruded anodised aluminium front panel.
On the rear panel It shall have Left and Right electronically balanced 3 pin female XLR input connectors, corresponding to Left and Right electronically balanced 3 pin male XLR output connectors.  
There shall also be Left and Right Recording Outputs on the rear panel. These outputs shall be transformer balanced male XLR connectors.
On the front panel there shall be LEDs to indicate that the Automatic Gain Control circuitry is active, and also that the unit is connected to AC Power.
There shall also be a Threshold control for the Automatic Gain Control (AGC) circuitry, from –40 dB through to 0dB and an associated Output Level control, from –20dB to +20dB

Maximum Output Level shall be +21dB, and Dynamic Range shall be 115dB. 
Output Signal/Noise @ unity gain shall be -90dB A weighted, Master @ unity, 
Frequency Response shall be 20Hz-20KHz ±1dB.
Distortion @ unity gain shall be below .0035%, 100Hz to 10KHz.
AC power shall be switchable 100 to 120V or 220 to 240V AC, connected to the unit via a standard three pin IEC connector, with built-in fuse and voltage change switch.
The unit shall be the ARX UniFace