Architect's Specifications


The mixer shall be mounted into a standard 1 RU steel chassis with extruded anodised aluminium front panel.
It shall have six input channels switchable to Mic or Line, with one Level control per input. Each level control shall provide full attenuation through to +6dB of gain. An associated Gain control shall have 10dB to 50 dB Gain

There shall also be a stereo Line input channel, with RCA type phone connectors. It shall have its own Level control, and an associated –10 to +10 dB Input Trim control.

On the rear panel, all Mic/Line Inputs shall be electronically balanced 3 pin female XLR  connectors.  
There shall be a Master Level control with three way EQ on the front panel, and the Master outputs shall be electronically balanced 3 pin male XLR output connectors. There shall also be a single transformer balanced XLR Auxiliary Master output with associated front panel Level control.

There shall also be a Recording Output Master control on the front panel, with associated Automatic Gain Control. The outputs shall be transformer balanced Tip Ring Sleeve balanced jacks.
48V DC Phantom Power shall be available on all Mic Inputs  via a rear panel switch

Input Headroom shall be +24dB, and Maximum Output Level shall be +24dB. 
Output Signal/Noise @ unity gain shall be -90dB A weighted, Master @ unity, 
Frequency Response shall be 20Hz-20KHz ±1dB.

Distortion @ unity gain, shall be below .0035% 100Hz to 10KHz.
AC power shall be switchable 100 to 120V or 220 to 240V AC, connected to the unit via a standard three pin IEC connector, with built-in fuse and voltage change switch.

The unit shall be the ARX UniMIX